What is the throttle actuator control system? A Throttle Kicker Actuator is a component of the throttle control which helps to regulate throttle control in situations where additional throttle is needed suddenly or when there is a sudden drop in throttle needed.
How much does it cost to replace a throttle actuator control system? How much does it cost to replace a throttle actuator? The average cost for throttle body replacement is between $548 and $571. Labor costs are estimated between $85 and $107 while parts are priced at $463. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
Where is the throttle actuator located? The throttle body is located between the air cleaner and the intake manifold of the engine. Most throttle bodies are made of aluminum. The throttle body is connected to the gas pedal of your vehicle with a linkage or flexible cable, which moves the throttle shaft when the gas pedal is depressed.
Can you drive with a bad throttle actuator? Can you drive with a bad throttle position sensor? It is not a good idea to drive with a bad throttle position sensor. Driving your car in this condition can be dangerous because your car might not accelerate properly or could suddenly accelerate without the driver pressing the gas pedal.
Table of Contents
What is the throttle actuator control system? – Related Questions
Can I drive with the throttle control warning light on?
Can I drive with the throttle control light on? Yes, usually, but you should go straight to a repair shop. There can be many different causes for the throttle control warning light, so a proper diagnosis is key.
What happens when the electronic throttle control goes bad?
When a TPS goes bad, then the car’s throttle body won’t function properly. It could either stay shut or it won’t close properly which is a severe issue. When the throttle gets stuck in an open position than your vehicle will receive too much air and cause it to have a high or fluctuating idle.
How do I reset my electronic throttle control manually?
Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.
Why does my throttle get stuck?
A sticky throttle could be caused by worn cables, lack of lubrication in the cables or the cable getting bound up somewhere in the mechanism. Or it can be caused by an issue with the carburetor or EFI. If the screws in the throttle housing are too tight it could cause the cable to stick.
How much does it cost to fix a throttle body?
The average cost for a Throttle Body Replacement is between $489 and $593 but can vary from car to car.
Can throttle body cause transmission problems?
The Throttle Position sensor measures the throttle position, which is controlled by the gas pedal. It is used to determine engine load and if it fails it can cause automatic transmission shifting problems.
What sensor would stop a car from starting?
Which sensors prevent the engine from starting? Faulty sensors can keep your engine from starting as a safety measure. For instance, the crank angle sensor, or crankshaft position sensor, may be located near the transmission belt housing and come in contact with water, which would prevent it from working.
What is the lightning bolt symbol on my dashboard?
The lightning bolt on the dash means that there is a problem with the electronic throttle control system in your vehicle. The light may be on for a glitch and the electronic throttle control system needs to be reset.
What does a lightning bolt mean on a car?
The lightning bolt warning light alerts you to a fault in the electronic throttle control system in your vehicle. This may be a faulty throttle body, the throttle body sensor or possibly the throttle body control motor which is what controls the opening and closing of the throttle body as the motor requires more fuel.
What does the electronic throttle control do?
Electronic throttle control facilitates the integration of features such as cruise control, traction control, stability control, and precrash systems and others that require torque management, since the throttle can be moved irrespective of the position of the driver’s accelerator pedal.
How do I reset my electronic throttle light?
Fully depress the accelerator pedal for 10 seconds. At this point the check engine light should change to blinking slowly indicating “Erasing ECU Memory”. 8. Release the accelerator pedal and turn the ignition switch to off.
How do you reset a throttle position sensor?
The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.
What happens if throttle cable is too tight?
When there is excess slack or the cable is too tight, this can cause intermittent delays in throttle response relative to pressing down on the accelerator pedal. This can also result in the opposite effect as well, in that the excess slack can create a delayed throttle return response.
What is the most common cause of a stuck accelerator?
A mat or carpet blocking the travel of the pedal is the most common reason.
How do you know if your throttle body is stuck?
When a throttle body is not functioning correctly, some noticeable characteristics may be poor or very low idle. This can include stalling when coming to a stop or very low idle after starting, or even stalling if the throttle is quickly pressed (resulting in the throttle body plate opening and closing very quickly).
Are throttle cables universal?
In today’s modern vehicles, throttle cables are obsolete with the widespread use of drive-by-wire throttle pedal assemblies. Our universal throttle cable offerings fit most any application or engine type and mounting location.
What should TPS be at idle?
At idle is should be zero or a couple of degrees. Press down on the gas pedal very S-L-O-W-L-Y until the throttle is all the way open. If the TPS has a worn spot, most likely it will be between 0 and 20 percent throttle opening. Try holding the throttle between 0 and 20 percent to see if you get a steady reading.
Should I clean or replace throttle body?
Generally, throttle bodies do not need to be replaced completely, but rather just need specific parts related to them replaced. I would also recommend checking the mass air flow sensor to be sure it is functioning correctly as well since this could also cause the car to hesitate or run poorly.
Can I clean throttle body without removing it?
You don’t need to remove a throttle body to clean it. If you have a DBW throttle body, DO NOT MOVE THE THROTTLE PLATE MANUALLY TO CLEAN IT, especially with the key in the ON position. Have them depress the gas pedal all the way to open the throttle plate so you can gain access to do your cleaning.
What causes code P2138?
The P2138 trouble code indicates that the Engine Control Module has detected a malfunction within the D and/or E circuits of the throttle position sensor.
Are throttle controllers bad?
No, throttle controllers are not bad for your car or truck. They do not directly connect with any programming modules and only manage electrical current in the gas pedal.